Dimmer - ZV9040A

ZV9040A
New product

kr. 398,40

10 Items
in stock

- +

Add to compare

Accessories

 
More info

Z-Wave Plus flush-mounted Universal Dimmer with Power Metering feature - ZV9040A from Sunricher.

The ZV9040A micro smart dimmer is a Z-Wave device designed to work with various types of light sources. It may be connected to two-wire or three-wire configuration so it can operate with or without neutral lead. The dimmer can switch or dim connected light source either through Z-Wave network or through the wall switch connected directly to it. The smart dimmer is equipped with an algorithm of smart light source detection which makes configuration easier and ensures high compatibility of the device. The innovative minimum brightness setting function enables users to set a minimum brightness level. It may be used as a switch with non-dimmable light sources (in 3-wire connection).

  • Communicates via Z-Wave Plus RF (868,42 MHz)
  • Range: up to 100m free field, up to 30m in buildings
  • Group for Association: 1 (Max 5 nodes)
  • Supports encryption mode: S0, S2
  • Support: Beaming and Z-Wave explorer frames
  • Over The Air (OTA) firmware upgrades
  • Dimmer type: Universal (bidirectional MOSFET switch)
  • Supported Loads: (Look User/Installation manual for more information)
  • Implemented algorithm of smart light source detection
  • Supports adjustment of the appropriate control mode (leading edge or trailing edge) to connected load
  • Soft start function
  • With memory function of the last lighting level settings
  • Innovative minimum brightness setting function
  • Active power and energy metering functionality
  • Works with various types of existing wired wall switches – momentary, toggle, three-way
  • Rated Current Output: Max 1,2A (for resistive loads)
  • Surge and Overload Protection
  • Max standby power: < 1W

Attention! This dimmer module suitable for dimming of low-voltage halogen lighting and LED based lamps. The dimmer does not work for every installation, because not every transformer or LED can be dimmed. Dimmable electronic transformers and LEDs as standard is marked as "DIMMABLE".
Non compatible light device may work but is likely can produce light flickering and (or) an audible humming or buzzing noise when dimmed. This noise and (or) flickering is usually a symptoms of internal stress, which in turn can cause failure of the connected device or dimmer.

 
Data sheet
ProtocolZ-Wave Plus S2
Device TypeSlave with routing capabilities, Multilevel Power Switch
Supports Z-Wave Beaming Technology?Yes
Supports Z-Wave Network Security?Yes
Supports Z-Wave AES-128 Security S0?Yes
Supports Z-Wave Security S2?Yes
Smart Start Compatible?No
Firmware Upgradable?Yes
Power Metering Feature?Yes
Executive ElementUniversal (Bidirectional MOSFET switch)
Load1,2A (for Resistive Loads)
Nominal Voltage100 - 240V AC, 50/60Hz
Operating Temperature0°C ~ 40°C
ProtectionIP20
Dimensions (L x W x H) mm45,5 x 45 x 20,3
ColorWhite
 
Download

User Manual - ZV9040A

User and Installation Manual - Sunricher ZV9040A

Download (144.91k)

Write a review

Dimmer - ZV9040A

Write a review

 
Comments(0)

No customer reviews for the moment.

30 other products in the same category:

Compare 0

No products

To be determined Shipping
kr. 0,00 Total

Check out