DiSEqC Switch - 10x1

SW101D
New product

kr. 598,00

1 Item
in stock
Warning: Last items in stock!

- +

Add to compare

 
More info

 DiSEqC switch 10x1 fra ASAT - SW101D.

When receiver has DiSEqC 1.0 and 1.2, recommended set to mode DiSEqC 1.2 (positioner commands). In this mode SW101D switch programmable like a DiSEqC positioner by receiver’s remote. At first set receiver to desirable satellite, set positioner mode to this satellite, go to positioner menu. Then user must set switch SW101D to programmable mode by pressing 3 times STORE SAT (this is to prevent of unwitting reprogramming of SW101D). In programmable mode SW101D is set until receiver is shut down power to LNB.
By pressing MOVE EAST or MOVE WEST user can change SW101D input from 1 to 10 in order decrement or increment. When SW101D switched to proper input, receiver’s signal strength increases, and then press STORE SAT and store this SW101D input. In the same way store other inputs for other satellites.
When programming complete, restart a satellite receiver. After connecting switch to LNB supply voltage (RECEIVER output), activated Input LNB1.

  • Frequency range: 950 - 2150 MHz
  • Operation voltage: 10 - 21V DC
  • Max. current: 500 mA
  • Short and overload protection on inputs: LNB1- LNB10
 
Data sheet
Device TypeDiSEqC Switch
Operating Temperature-34°C ~ 60°C
ProtectionIP44
ColorGrey

Write a review

DiSEqC Switch - 10x1

Write a review

 
Comments(0)

No customer reviews for the moment.

16 other products in the same category:

Compare 0

No products

To be determined Shipping
kr. 0,00 Total

Check out