Dimmer - S2222E

Reduced price!
New product

kr. 258,40

kr. 358,40

-kr. 100,00

3 Items
in stock
Warning: Last items in stock!

- +

Add to compare


More info

 X-10 (2-Wire) Dimmer Module - S2222E from Super.

Single-button Wall mounted dimmer. As the S2222E is a 2-wire type Module it can control only incandescent lamps. Module can not be used for inductive and capacitive loads like Fluorescent and Energy-saver lamps, low-voltage halogen lighting with electronic transformer. Can be controlled with any X-10 controller through the existing house wiring or by hand. Provided with a soft start, soft dim and a memory for the last dim level. The unit’s Address and Options data are all stored in permanent memory and are preserved through a loss of power.

  • Communicates via X-10 Powerline: 120 kHz ± 2 kHz / 2.5 Vpk-pk
  • Signal Sensitivity: better than 25 mVpp at 120 kHz
  • X-10 key codes to respond to: All units Off, All Lights On, On, Off, Dim, Bright
  • Load capacity: 60 - 300W (for Resistive Loads)
  • Soft start and smooth dimming features
  • Power consumption: < 1W

 Attention! The module is not suitable for dimming and controlling low-energy light bulbs and tube lighting. An Appliance module should be used.

 Note! 2-Wire installation. Neutral wire not required.

Data sheet
Device TypeDimmer Module
Executive ElementTRIAC (Leading Edge/Phase Control dimming mode)
Load60 - 300W (for Resistive Loads)
Nominal Voltage230V AC ± 10%, 50Hz
Operating Temperature-10°C ~ 50°C
Dimensions (L x W x H) mm93 x 85 x 25

User Manual - S2222E

User and Installation Manual - Super S2222E

Download (64.45k)

Write a review

Dimmer - S2222E

Write a review


No customer reviews for the moment.

10 other products in the same category:

Compare 0

No products

To be determined Shipping
kr. 0,00 Total

Check out