Z-Wave Single Wall Mounted (2-Wire) Dimmer Receiver - 05433-EX from Z-Wave.Me.
The 05433-EX is delivered as a complete set with flush mountable insert, paddle and mounting frame compatible with the design of the Duewi switching series Everluxe in standard white. The paddle of the device is used to control the device itself but can also be configured to activate scenes in an (supported) IP gateway or controller. The status of the dimmer (if configured) - will be reported back to a central IP gateway or controller. The function of the local paddle can be configured as detached from the local operation. This device is designed for a 2-wire system. There is no need for a neutral (N) wire in the wall box.
- Communicates via Z-Wave RF (868,42 MHz)
- Range: up to 30m indoors
- Manual operation via 1-gang push-on button
- Group for Association: 3 (Max 14 nodes in Group)
- Load HV-Halogen and incandescent bulbs: 25 - 300W
- Load LV-Halogen with iron core transformer: 40 – 300VA
- Standby Power consumption: < 1W
- Fuse Type: T 1,25 A H (Load 1.25 Ampere, high shutdown capacity)
- Display elements: LED
Attention! The 05433-EX dimmer module using a leading edge/phase cutting technology with a special alignment algorithm for inductive loads. Therefore, it is possible to dim incandescent lamps, high voltage halogen lights and low voltage halogen lights with traditional transformer. Halogen lights with switching power supply, LEDs and CFLs must not be attached to this dimmer.