VCR Commander Sale

VCR Commander

Reduced price!
New product

kr. 158,40

kr. 758,40

-kr. 600,00

1 Item
in stock
Warning: Last items in stock!

- +

Add to compare

More info

 VCR Commander - UX23E from Marmitek.

The VCR Commander learns a sequence of up to 4 different IR commands (labeled PWR, REC, PLAY, and STOP) and up to 4 different motion sensor signals. You teach the IR commands by selecting the button on the VCR Commander II (UX23E) to learn for and then using the VCR remote control to emit that command to the VCR Commander. Learning motion sensor codes is done in a similar manner. When the On command from the programmed X-10 address is received, the VCR Commander will issue the programmed IR sequence to the VCR through the IR emitter cable. More On commands (signals of further motion) within 5 minutes will be ignored. If no more On commands are seen within 5 minutes (no further motion), the VCR Commander II will issue the IR "Stop" command. After the "Stop" command is issued an On command will start the cycle over again. Because of this, it is recommended that you shouldn't use the "PWR" command as part of their record sequence, and should instead leave their VCR on all the time.

  • Communicates via X-10 RF (433,92 MHz)
  • IR codes learn function
Data sheet
Device TypeCamera Accessories
Nominal Voltage9V DC / 100mA (via External Power Supply)
Operating Temperature0°C ~ 40°C
Dimensions (L x W x H) mm88 x 110 x 35

User Manual - UX23E

User and Installation Manual - Marmitek UX23E

Download (139.88k)

Write a review

VCR Commander

Write a review


No customer reviews for the moment.

4 other products in the same category:

Compare 0

No products

To be determined Shipping
kr. 0,00 Total

Check out