Universal Sensor - FGBS-222

FGBS-222
New product

kr. 398,40

7 Items
in stock

- +

Add to compare

Accessories

 
More info

Z-Wave Plus Smart Implant Sensor - FGBS-222 from Fibaro.

FIBARO Smart Implant allows to enhance the functionality of wired sensors and other devices by adding Z-Wave network communication. You can connect binary sensors, analog sensors, DS18B20 temperature sensors or DHT22 humidity and temperature sensor to report their readings to the Z-Wave controller. It can also control devices by opening/closing output contacts independently of the inputs.
Whether to control your garage door or the heating system, as an intelligent supplement to your alarm system or simply to make every device smart in your home. The FIBARO Smart Implant can also be connected to sensors in the garden that the Smart Home does not end at the front door. As a further development of the Universal binary Sensor, the FIBARO Smart Implant controls the connected device, can be used for scene control, has a temperature sensor and is compatible with binary sensors.

  • Communicates via Z-Wave Plus RF (868,42 MHz)
  • Range: up to 50m free field, up to 40m in buildings
  • Group for Association: 3 (Group 1 support 1 node, Group 2 - 3 support 5 nodes)
  • Security: Mode S0 with AES-128 and S2 encryption with PRNG
  • Over The Air (OTA) firmware upgrades
  • Inputs: 2x 0-10V or digital inputs, 1x serial 1-wire input
  • Outputs: 2 potential-free outputs (independently control)
  • Supported digital sensors: 6x DS18B20 or 1x DHT22
  • Built-in temperature sensor
  • Built-in temperature sensor measurement range: -55°C ~ 126°C
  • Maximum current carrying capacity of outputs: 150mA
  • Maximum voltage at output contacts: 30V DC / 20V AC ±5%
  • Supply voltage: 9-30V DC ±10%

In order to connect the DS18B20 sensors it is recommended to use conductors made from a single wire with a length of up to 30 meters.

Attention! Smart Implant Sensor - FGBS-222 is not an battery operated device. It is always awake so it can route Z-Wave frames.

Click here to visit Fibaro Support page for Smart Implant Sensor

 
Data sheet
ProtocolZ-Wave Plus S2, Smart Start
Device TypeRouting Binary Sensor
Supports Z-Wave Beaming Technology?Yes
Supports Z-Wave Network Security?Yes
Supports Z-Wave AES-128 Security S0?Yes
Supports Z-Wave Security S2?Yes
Smart Start Compatible?Yes
Firmware Upgradable?Yes
Nominal Voltage9-30V DC ±10%
Operating Temperature0°C ~ 40°C
ProtectionIP20
Dimensions (L x W x H) mm29 x 18 x 13
ColorWhite
 
Download

User Manual - FGBS-222

User and Installation Manual - Fibaro FGBS-222

Download (761.26k)

Write a review

Universal Sensor - FGBS-222

Write a review

 
Comments(0)

No customer reviews for the moment.

30 other products in the same category:

Customers who bought this product also bought:

Compare 0

No products

To be determined Shipping
kr. 0,00 Total

Check out