VCR Commander Salg

VCR Commander

Redusert pris!
Ny produkt

kr. 158,40

kr. 758,40

-kr. 600,00

1 enhet
på lager
Advarsel: Siste vare på lager!

- +

Legg til i sammenligningen

Mer info

 VCR Commander - UX23E from Marmitek.

The VCR Commander learns a sequence of up to 4 different IR commands (labeled PWR, REC, PLAY, and STOP) and up to 4 different motion sensor signals. You teach the IR commands by selecting the button on the VCR Commander II (UX23E) to learn for and then using the VCR remote control to emit that command to the VCR Commander. Learning motion sensor codes is done in a similar manner. When the On command from the programmed X-10 address is received, the VCR Commander will issue the programmed IR sequence to the VCR through the IR emitter cable. More On commands (signals of further motion) within 5 minutes will be ignored. If no more On commands are seen within 5 minutes (no further motion), the VCR Commander II will issue the IR "Stop" command. After the "Stop" command is issued an On command will start the cycle over again. Because of this, it is recommended that you shouldn't use the "PWR" command as part of their record sequence, and should instead leave their VCR on all the time.

  • Communicates via X-10 RF (433,92 MHz)
  • IR codes learn function
EnhetstypeKamera Tilbehør
Nominell spenning9V DC / 100mA (via External Power Supply)
Driftstemperatur0°C ~ 40°C
Størrelse (L x B x H) mm88 x 110 x 35
Last ned

Brukerveiledning - UX23E

Installasjon og brukerveiledning - Marmitek UX23E

Last ned (139.88k)

Skriv en produktanmeldelse

VCR Commander

Skriv en produktanmeldelse


Ingen kundeanmeldelser for øyeblikket.

4 andre produkter i samme kategori:

Sam-lign 0

Ingen produkter

Avgjøres senere Frakt
kr. 0,00 Totalbeløp

Gå til kasse