Termostat - Z-TRM2fx

5430460
Ny produkt

kr. 1.448,00

23 enheter
på lager.

- +

Legg til i sammenligningen

Tilbehør

 
Mer info

 Z-Wave Plus Controlled Thermostat - Z-TRM2fx from Heatit.

Heatit Z-TRM2fx is an electronic thermostat with power metering feature for mounting in a standard wall box. The thermostat has a built-in Z-Wave chip and can be connected to Home Automation systems like Fibaro, Sensio, VERA, Zipato and others. The temperature shown in the display is the actual temperature for floor sensor and the external room sensor. When using the internal room sensor, the temperature shown is the set point. Z-TRM2fx thermostat equipped with a single-pole switch and can handle loads up to 13A/2900W at 230V. If the load is greater than this, the thermostat needs to be connected to an contactor. It can be used with two external temperature sensors.

  • Communicates via Z-Wave Plus RF (868,42 MHz)
  • Range: up to 30m in buildings
  • Standard and enhanced security: S0 (AES-128 encryption), S2
  • Over The Air (OTA) firmware upgrades
  • Group for Association: 4 (Max. 8 nodes per Group)
  • Display: LED-display 3x 7-segment, 13.2mm, CA white
  • Lock mode/Child lock
  • Operating Temperature Range: 5 - 40°C
  • Hysteresis: 0,3°C to 3,0°C (default: 0,5°C)
  • Temperature setback: Adjustable within temperature range
  • Temperature setback activation via: Pilot wire/User interface/Z-Wave gateway
  • Power metering feature
  • Switch Contact rating: 2900W or 13A resistive, 750W self-limiting heating cable
  • Power regulator: Time cycle 0 - 30min
  • Power Supply: 230V AC 50/60 Hz
  • Power Consumption: <2,0W
  • Compatible with NTC sensors: 10, 12, 15, 22, 33 and 47kΩ @ 25°C
  • Sensors: Built-in room sensor and floor sensor NTC (10kΩ, 3 meters floor sensor included)
  • Support for external sensor NTC (not included)
  • Unit frame included
  • Easy Front Panel replacement (to another color) - optional
  • Can be used with frames from: ELKO (RS-16, Plus), Schneider Exxact, Eljo Trend, ELSO, Norvesco, Berker (S.1, B.1, B.3, B.7 Glass), GIRA (System 55, Standard 55, E2, E22, Event, Esprit), Merten (1-M, Atelier-M, M-Smart, M-Arc, M-Star, M-Plan), JUNG (A 500, AS 500, A Plus, A Creation)

 Note: Wooden floor with electric underfloor heating requires that a floor sensor is connected. Thus, floor temperature is limited to 27°C.

 
Datablad
ProtokollZ-Wave Plus S2
EnhetstypeTermostat
Støtter Z-Wave Beaming teknologi?Ja
Støtter Z-Wave nettverkssikkerhet?Ja
Støtter Z-Wave AES-128 sikkerhet S0?Ja
Støtter Z-Wave sikkerhet S2?Ja
Smart Start kompatibel?Nei
Firmware oppgraderbar?Ja
Strømmålingsfunksjon?Ja
StyreelementRelay
Maksimal belastning2900W eller 13A ved 230V AC
Nominell spenning230V AC 50/60 Hz
Driftstemperatur5°C ~ 40°C
BeskyttelseIP21
Størrelse (L x B x H) mm58 x 58 (Front) x 50
FargeHvit
 
Last ned

Brukerveiledning - Z-TRM2fx

Installasjon og brukerveiledning - Heatit Z-TRM2fx

Last ned (500.29k)

Skriv en produktanmeldelse

Termostat - Z-TRM2fx

Skriv en produktanmeldelse

 
Kommentarer(0)

Ingen kundeanmeldelser for øyeblikket.

 
Videopresentasjoner

30 andre produkter i samme kategori:

Kunder som kjøpte dette produktet kjøpte også:

Sam-lign 0

Ingen produkter

Avgjøres senere Frakt
kr. 0,00 Totalbeløp

Gå til kasse