Wall Controller - ZV9002T4-CCT

Z-Wave Plus CCT Wall Mounted Touch panel Controller - ZV9002T4-CCT.

This Touch Wall Controller allows CCT color temperature control and Scenes activation in Gateway. The ZV9002T4-CCT Wall Controller cannot act as Z-Wave network administrator and will always need a Z-Wave (Primary) network controller to be included into a Z-Wave network.
The Wall Controller has Tempered glass panel with capacitive touch buttons.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• RF Range: Up to 30m in buildings
• Group for Association: 5 (Group 1 support 1 node, Group 2 - 5 support 12 nodes)
• Supports “Central Scene Notification V3”
• Supports “Scene Activation V1” via buttons S1, S2, S3 and S4 *
• Supports encryption mode: S0, S2
• Supports Beaming and Z-Wave explorer frames
• Over The Air (OTA) firmware upgrades
• Multilevel Remote Switch
• Installation: Flush mounted in standard European (∅ 60 mm) junction box
• Standby Power consumption: < 0,5W
• Display elements: LED

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! The ZV9002T4-CCT Wall Mounted Touch panel Controller doesn't support Z-Wave network administration.

* For use of this feature respective receiver nodes must have support for Command Classes: COMMAND_CLASS_SCENE_ACTIVATION and COMMAND_CLASS_SCENE_ACTUATOR_CONF.