The Z-PI-V01 interface from ZVIDAR turns every Raspberry PI into a Z-Wave Home Automation Gateway.
Use this 800 Series Z-Wave Plus Pi Module as a wireless radio for your host controller, such as Raspberry Pi.
- Communicates via Z-Wave 800 RF (868,42 MHz)
- Based on ZenSys 7.18.3 or later
- Adapter is firmware upgradeable
- Range: Min. 40m in direct line of sight
- Tunable transmit power for bigger range
- Interface: 3.3 V TTL UART compatible with Raspberry Pi GPIO pins
- Designed for Raspberry Pi and Home Assistant Yellow hardware
Z-PI-V01
Data sheet
- Protocol
- Z-Wave 800
- Device Type
- Static Controller
- Supports Z-Wave Beaming?
- Yes
- Supports Z-Wave Network Security?
- Yes
- Smart Start Compatible?
- Yes
- Firmware Upgradable?
- Yes
- Operating Temperature
- 0°C ~ 40°C
- Protection
- IP10
- Dimensions L x W x H (mm)
- 50,4 x 19 x 7,4
10 other products in the same category:
English
Norsk