Power Meter - ZMNHTD1

DIN-rail Power Meter - ZMNHTD1 from Qubino.

This Power Meter module is used for energy measurements in single-phase electrical power network and can be used in residential, industrial and utility applications. Meters measure energy directly in 2-wire networks according to the principle of fast sampling of voltage and current signals. A built-in microprocessor calculates energy, power and power factor from the measured signals. The module can be controlled through Z-Wave network and it acts as repeater in order to improve range and stability of Z-Wave network. Optional (via IR signal) external relay control (BICOM432-40-WM1).

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 30m indoors
• Group for Association: 1 (Lifeline group reserved for communication with the main controller)
• Supports encryption mode: S0, S2
• Over The Air (OTA) firmware upgrades
• Type (connection): Single Phase (1b)
• Maximum current (Imax): 65A
• Power consumption: < 2W
• Integrated IR signal emitter
• Display elements: LED for status display

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Note: For 1-phase installation.

Click here to visit Qubino Products Compatibility List