
Z-Wave Plus Strike Lock Door Opener Set - 700007 from Popp.
With the first Z-Wave Plus controlled Door Opener the house entrance door, especially in multi-family houses, can be integrated into Home Automation system. The Controller device communicates encrypted with the Z-Wave control center and enables wireless door opening with remote controls, smartphone or tablet PC. This way you can enter the house without using a key. Furthermore you can open the door for your children when on the move.
This product set consists of 2 parts. The Controller Module and an Electric Door Opener for the door lock. If your home does not have a electronic door control, intercom or other modules, you can easily upgrade your home with the POPE700007. The Door Opener has to be installed in the existing door lock setup. Then you can connect the Controller Module with the Electric Door Opener.
The Door Opener works with battery or can be powered over the bell transformer’s power supply. It is also possible to connect door mechanisms with monitor contact.
- Communicates via Z-Wave Plus RF (868,42 MHz)
- Range: up to 100m outside, on average up to 40m inside buildings
- Group for Association: 2 (Max 10 nodes per Group)
- Security: AES-128 bit data encryption
- Explorer Frame Support
- Over The Air (OTA) firmware upgrades
Click here to visit Aeotec Support page for Strike Lock Control
Data sheet
- Protocol
- Z-Wave Plus
- Device Type
- Sensor
- Supports Z-Wave Beaming?
- Yes
- Supports Z-Wave Network Security?
- Yes
- Supports Z-Wave Security S0?
- Yes
- Supports Z-Wave Security S2?
- No
- Firmware Upgradable?
- Yes
- Executive Element
- Relay
- Nominal Voltage
- 8-12V AC / 8-24V DC or 9V Block battery
- Operating Temperature
- -10°C ~ 30°C
- Protection
- IP44
- Dimensions L x W x H (mm)
- Controller: 55 x 26 x 15; Door Opener: 61.8 x 16.5 x 25.5