Z-Wave Plus V2 Recessed Door Sensor - ZW187 from Aeotec.
The Aeotec battery-powered Z-Wave Plus V2, magnetic Door Sensor with an extremely small form factor. The beauty of an invisible installation is complemented by the beauty of a straightforward installation. Installing Recessed Door Sensor 7 is easy. And pairing it with an automation system takes no more than activating its battery and scanning its QR code. Making the whole thing invisible means little more than a drill hole hidden away on the loop of a door. It's the sort of installation that takes no more than 10 minutes but provides years' worth of automation intelligence.
- Communicates via Z-Wave Plus V2 RF (868,42 MHz)
- Range: up to 150m in a free field
- Supports encryption mode: S2 Authenticated, S2 Unauthenticated
- Over The Air (OTA) firmware upgrades
- Group for Association: 2 (Max 5 nodes per Group)
- Low battery detection
- Hidden tamper prevention trigger
Click here to visit Aeotec Support and Firmware Update page for Recessed Door Sensor 7
ZW187-C
Data sheet
- Protocol
- Z-Wave Plus V2
- Device Type
- Binary Sensor
- Supports Z-Wave Beaming?
- No
- Supports Z-Wave Network Security?
- Yes
- Supports Z-Wave Security S2?
- Yes
- Smart Start Compatible?
- Yes
- Firmware Upgradable?
- Yes
- Nominal Voltage
- 1x (3.0V) Lithium CR2 battery
- Operating Temperature
- 0°C ~ 40°C
- Protection
- IP20
- Dimensions D x H (mm)
- 19.2 x 64 (main sensor), 22 x 13 (magnet unit)
- Color
- White
18 other products in the same category:
English
Norsk