Z-Wave Plus flush-mounted, Pilot Wire - ZMNHJD1 from Qubino.
This Z-Wave Plus module is used to control electric Radiators with 6 different working modes by pilot wire control signal. The module can be controlled either through a Z-Wave network or through the wall switch. Module supports connection of digital temperature sensor. It is designed to act as repeater in order to improve range and stability of Z-Wave network.
- Communicates via Z-Wave Plus RF (868,42 MHz)
- Range: up to 50m free field, up to 30m in buildings
- Group for Association: 5 (Group 1 support 1 node)
- Operation modes: 6
- Module supports mono-stable and bi-stable switches (input I)
- Rated load current of AC output (resistive load): 0.85A/200W (230V AC)
- With memory function of the device state after a power failure
- Temperature control via connected sensor (optional)
- Power consumption: 0,7W
IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself
ZMNHJD1
Data sheet
- Protocol
- Z-Wave Plus
- Device Type
- Slave with routing capabilities, Multilevel Switch
- Firmware Upgradable?
- Yes
- Load
- 200W (for Resistive Loads) or 0.85A/230V AC
- Nominal Voltage
- 230V AC ±10% 50Hz
- Operating Temperature
- -10°C ~ 40°C
- Protection
- IP20
- Dimensions L x W x H (mm)
- 37 x 42 x 16
- Color
- Blue
Customers who bought this product also bought:
18 other products in the same category:
English
Norsk