Thermostat ON/OFF - ZMNKID1

Z-Wave Plus flush-mounted ON/OFF Thermostat 2 from Qubino - ZMNKID1 with Power Metering feature.

The Qubino On/Off Thermostat 2 is your wireless heating and hot water controller that also measures the power consumption. This amazingly tiny module is ideal for wireless control of electric or water-based underfloor heating systems, electric water heaters, hot water pumps, and electric radiators.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 40m in buildings
• Group for Association: 4 (Maks 5 noder per Gruppe)
• Supports encryption mode: S0, S2
• Support: Beaming and Z-Wave explorer frames
• Over The Air (OTA) firmware upgrades
• Functions: Switch ON, switch OFF, Power Metering
• Module supports mono-stable switches (push button) and bi-stable switches.
• Rated load current of AC output (resistive load)*: 1 x 10A (230V AC)
• Rated load current of DC output (resistive load)*: 1 x 10A (30V DC)
• Output circuit power of AC output (resistive load) = 1 X 2300W (230V AC)
• Output circuit power of DC output (resistive load) = 1 X 240W (24V DC)
• Power measurement accuracy: 5 - 50W (±3W); ˃ 50W (±3%)
• Power consumption: 0,4W
• Temperature control via connected DS18B20 sensor (included)
• Temperature Detecting Range: from -25°C to +80°C
• Temperature Accuracy: ±0,1°C

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! The floor sensor should be laid in an installation pipe that is cast into the floor. This pipe should be sealed at the end and laid as high as possible in the cast. The sensor cable can be extended. The sensor cable should not be laid in parallel with cables carrying large currents, as this may induce unwanted signals.

Note: Wooden floor with electric underfloor heating requires that a floor sensor is connected. Thus, floor temperature is limited to 27°C.

Click here to visit Qubino Support page for Flush On/Off Thermostat 2

Click here to visit Qubino Products Compatibility List