Klikk for flere produkter.
Ingen produtter ble funnet.

VCR Commander

ART-NR:
UX23E
Begrenset spesialtilbud
kr. 108.40 kr. 758.40
Siste vare(r) på lager: 1 stk.
Legg til for sammenligning0
Liker0
Legg i ønskeliste
Produsent:
Lignende produkter
Ingen produkter
Beskrivelse

VCR Commander - UX23E from Marmitek.

The VCR Commander learns a sequence of up to 4 different IR commands (labeled PWR, REC, PLAY, and STOP) and up to 4 different motion sensor signals. You teach the IR commands by selecting the button on the VCR Commander II (UX23E) to learn for and then using the VCR remote control to emit that command to the VCR Commander. Learning motion sensor codes is done in a similar manner. When the On command from the programmed X-10 address is received, the VCR Commander will issue the programmed IR sequence to the VCR through the IR emitter cable. More On commands (signals of further motion) within 5 minutes will be ignored. If no more On commands are seen within 5 minutes (no further motion), the VCR Commander II will issue the IR "Stop" command. After the "Stop" command is issued an On command will start the cycle over again. Because of this, it is recommended that you shouldn't use the "PWR" command as part of their record sequence, and should instead leave their VCR on all the time.

  • Communicates via X-10 RF (433,92 MHz)
  • IR codes learn function
Les merShow less
Produkt detaljer
UX23E

Datablad

Protokoll
X-10
Enhetstype
Kamera Tilbehør
Nominell spenning
9V DC / 100mA (via External Power Supply)
Driftstemperatur
0°C ~ 40°C
Beskyttelse
IP20
Størrelse L x B x H (mm)
88 x 110 x 35
Farge
Svart
Vedlegg
Brukerveiledning - UX23E
Installasjon og brukerveiledning - Marmitek UX23E
Last ned (139.88KB)
Anmeldelser
Ingen anmeldelser ennå.
3 andre produkter i samme kategori:

Menu

Innstillinger

Legg til for sammenligning0

Lag en konto for å lagre produkter som du liker.

Logg inn

Opprett en konto for å bruke ønskeliste.

Logg inn