Bryter 1-veis - FGS-213-ZW5

 Z-Wave Plus flush-mounted, 1-way Switch from Fibaro - FGS-213-ZW5 with Power Metering feature.

Thanks to its small size it can be mounted in junction boxes or inside device casings. The module is controlled either through the Z-Wave network or a simple switch. Power and energy usage measurement feature allows you to monitor and lower your utility bills.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 50m free field, up to 40m in buildings
• Security: AES-128 encryption
• Over The Air (OTA) firmware upgrades
• Group for Association: 5 (Group 1 support 1 node, Group 2 - 5 support 5 nodes)
• Works with various types of switches – momentary, toggle, three-way, etc.
• Rated load output: 8A/230V AC, 50/60Hz (for Resistive load)
• Active Power and Energy metering functionality
• Power measurement accuracy: ±1% for loads greater than 5W
• Alarm data frames support
• Built-in scene activation mechanism
• Smart hardware Error modes and messages
• Z-Wave network coverage tester feature
• Overheating and overcurrent protection
• Overcurrent protection: Required external 10A circuit breaker
• Power consumption: < 1.3W

VIKTIG! Kan kun installeres av en autorisert elektroinstallatør fra registrert installasjonsvirksomhet. Privatpersoner som ønsker selv utføre arbeid på det elektriske anlegget må studere først info fra dsb (Direktoratet for samfunnssikkerhet og beredskap) - Elektrisk arbeid: Dette kan du gjøre selv

Attention! This switch module don't have potential free relay output.

Click here to visit Fibaro Support page for Single Switch 2