ZigBee 3.0 Plug-in Dimmer Module (EU-Schuko plug) - D080-ZG from HZC electric.
The D080-ZG is an innovative AC phase-cut dimmer with ZigBee 3.0 control interface. The innovative minimum brightness setting function enables users to set a minimum brightness level. Work with: Amazon Alexa, Google Assistant Home, Philips hue and more.
- Communicates via ZigBee 3.0 RF (2,4 GHz)
- RF Range Typical: 40 meters
- Functions: Switch ON, switch OFF, DIM
- Compatible with universal ZigBee Master Controller/Coordinator
- Supports Touchlink commissioning
- Supports Find and Bind mode to bind a ZigBee remote directly without coordinator
- Prepared for OTA software update
- Dimmer type: Trailing edge (bidirectional MOSFET switch)
- Supported Loads: 5 - 100VA LED, 5 - 100W Halogen/Incandescent lamps
- Innovative minimum brightness setting function
Attention! This dimmer module suitable for dimming of low-voltage halogen lighting and LED based lamps. The dimmer does not work for every installation, because not every transformer or LED can be dimmed. Dimmable electronic transformers and LEDs as standard is marked as "DIMMABLE".
Non compatible light device may work but is likely can produce light flickering and (or) an audible humming or buzzing noise when dimmed. This noise and (or) flickering is usually a symptoms of internal stress, which in turn can cause failure of the connected device or dimmer. Always confer with professional installer.
Data sheet
- Protocol
- ZigBee 3.0
- Device Type
- Slave with routing capabilities, Multilevel Switch
- Firmware Upgradable?
- Yes
- Executive Element
- MOSFET (Trailing edge dimmer)
- Load
- 5 - 100W (for Resistive Loads)
- Nominal Voltage
- 220 - 240V AC, 50Hz
- Operating Temperature
- 0°C ~ 40°C
- Protection
- IP20
- Dimensions L x W x H (mm)
- 108,8 x 54,8 x 87,2
- Color
- White