Dimmer - CCT5010

ZigBee 3.0 flush-mounted Dimmer - CCT5010-0002W from Schneider Electric.

The Wiser™ dimmer with ZigBee 3.0 control interface. Device connected in two-wire configuration so it can operate without neutral (N) wire.

• Communicates via ZigBee 3.0 RF (2,4 GHz)
• RF Range Typical: 40 meters
• Prepared for OTA software update
• Compatible with universal ZigBee Master Controller/Coordinator
• Functions: Switch ON, switch OFF, DIM
• Maximum number of connected ZigBee devices: 15
• Extension connection: Maximum 10 mechanical double push-buttons
• For resistive, inductive and capacitive loads
• Load: (Look User/Installation manual for more information)
• Installation: with 2-wires only (no neutral wire required)
• Max standby power: 0,4W

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! This dimmer module suitable also for dimming of halogen lighting and LED based lamps. The dimmer does not work for every installation, because not every transformer or LED can be dimmed. Dimmable electronic transformers and LEDs as standard is marked as "DIMMABLE". Note: 230V (HV) halogen lamps and some of the LED based light sources have very high starting current.
Non compatible light device may work but is likely can produce light flickering and (or) an audible humming or buzzing noise when dimmed. This noise and (or) flickering is usually a symptoms of internal stress, which in turn can cause failure of the connected device or dimmer. Always confer with professional installer.

Click here to visit Schneider Electric Support page for Wiser Micro Dimmer

Click here to visit CCT5010-0002W Products Compatibility List