Switch/Controller - HE-TPS

Z-Wave Plus V2 Wall Mounted Switch/Controller - HE-TPS from Heltun.

The HELTUN TPS wall touch panel switch/controller replaces an existing in-wall switch and enables manual or remote switch (On/Off) control of lights, blinds, motors and heating systems with a maximum load of 5A for each channel.
Device has two independent inputs for the relay channels which allows it to control systems with different power sources or to use outputs as dry contacts. Each relay can be controlled by the switcher touch buttons or independently via a Z-Wave gateway.
The touch panel has five sensitive capacitive touch control buttons with a two-color (red and blue) backlight for each button. Button backlight brightness can be adjusted automatically depending on the illumination of the ambient environment or manually in the settings.
Each touch button can be configured to control any relay (from one up to five) output state in 7 different modes. The buttons also can be used as controller scene activators and the backlight can indicate the gateway mode or associated device status.
The HELTUN wall panel switch has internal air temperature sensor, humidity and light sensors and is also equipped with built-in power consumption logic.

• Communicates via Z-Wave Plus V2 RF (868,42 MHz)
• RF Range Typical: up to 100m in a free field, up to 30m in buildings
• Standard and enhanced security: S0 (AES-128 encryption), S2
• Over The Air (OTA) firmware upgrades
• Supports Scenes and Associations
• Relay switching with HELTUN Advanced Zero-Crossing Technology
• Red and Blue color LED back light for each button
• Buttons back light: 10 levels adjustable brightness
• All touch buttons can be assigned free
• Independent control of each relay and LEDs
• Relay output: Resistive load up to 5A each
• 2 independent relays outputs (potential free)
• Measured temperature range: -30°C to +80°C
• Temperature measurement accuracy: ±0.5°C
• Measured humidity range: 0 - 80% RH
• Humidity measurement accuracy: ±3.0% RH
• Internal ambient light sensor measuring range: 0 - 30000 Lux
• Software energy consumption meter logic
• Power Supply: 85-265VAC 50/60Hz, 24-48VDC
• Power consumption: 1.0W

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! This switch module have potential free relay outputs.

Click here to visit Heltun Support page for Z-Wave 700 Touch Panel Switch - HE-TPS