Switch 1-way - FGS-214

Z-Wave Plus flush-mounted, 1-way Smart Switch from Fibaro - FGS-214.

Thanks to its small size it can be mounted in junction boxes or inside device casings. The module is controlled either through the Z-Wave network or with buttons connected directly. Supports Z-Wave network Security Modes: S0 with AES-128 encryption and S2 Authenticated with PRNG-based encryption. Works as a Z-Wave signal repeater (all non-battery operated devices within the network will act as repeaters to increase reliability of the network). May be used with all devices certified with the Z-Wave Plus certificate and should be compatible with such devices produced by other manufacturers.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 50m free field, up to 40m in buildings
• Security: Mode S0 with AES-128 and S2 encryption with PRNG
• Over The Air (OTA) firmware upgrades
• Group for Association: 2 (Group 1 support 1 node, Group 2 support 5 nodes)
• Works with various types of switches and buttons
• Compatible load types: Resistive or Incandescent only
• Rated load output: 6,5A
• Alarm data frames support
• Built-in scene activation mechanism
• Z-Wave network coverage tester feature
• Power consumption: < 1.3W

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! This switch module have potential free relay output.

Click here to visit Fibaro Support page for Smart Module