Switch 2-way - Dual Nano Switch

Z-Wave Plus flush-mounted, 2-way Switch from Aeotec - ZW132 with Power and Energy metering functionality.

Aeotec Dual Nano Switch is a Z-Wave Smart Switch specifically used to enable Z-Wave command and control (ON/OFF) of any wall switches. In the event of power failure, non-volatile memory retains all programmed information relating to the unit’s operating status.
It can connect to 2 external manual switches to control the load ON/OFF independently. Its surface has a pin socket, which can be used for connecting to the touch panel, so you can also use the touch panel to control the Nano Switch.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 150 meters outdoors
• Security: AES-128 encryption
• Over The Air (OTA) firmware upgrades
• Group for Association: 4 (Max 5 nodes per Group)
• Works with various types of switches – momentary, toggle, three-way, etc.
• Rated load output: 2x 6,5A/230V AC, 50/60Hz; 2x 6,5A/24V DC (for Resistive load)
• Total current: Max. 10A
• Active Power and Energy metering functionality
• Power measurement accuracy: ±3W
• Inbuilt surge protection
• Device Power input: AC230V or DC24V
• Power consumption: < 0.8W

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! ZW132 switch module don't have potential free relay output.

Click here to visit Aeotec Support and Firmware Update page for Dual Nano Switch

Click here to visit Aeotec Products Compatibility List