Switch 6-way - Z-DIN 616

Z-Wave Plus DIN Rail Switch 6-way - Z-DIN 616 from Heatit.

Heatit Z-DIN 616 is a 6 x 16A potential free relays for DIN rail miounting. The module is equipped with 6 relay switches and 6 digital inputs for mounting on a standard M36 DIN rail (EN50022).
The 6 independent relay switches of the Heatit Z-DIN 616 can freely be controlled from the Z-Wave network and be used for many different purposes. All 6 relay switches are galvanically isolated from each other. and may be used for controlling AC and/or DC loads. Each relay switch is rated for loads of up to a maximum of 16A.
The 6 digital inputs can be connected to dry contacts, e.g. limit switches, door/window contacts, or push-buttons. Another option is to connect them to open-collector outputs from discrete sensors, e.g. PIR sensors. The 6 inputs of the Heatit Z-DIN 616 may also function as a scene controllers and activate predefined scenes in other Z-Wave devices or controllers (by transmitting Central Scene notifications).
The Heatit Z-DIN 616 is supplied from a 10 – 24V DC/8 - 24V AC power supply. Initiation of Z-Wave inclusion and exclusion is executed by activating a push-button through a little hole in the front of the module. The Heatit Z-DIN 616 is equipped with a LED in the front of the module for different kinds of status indications.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 30m in buildings
• Group for Association: 4 (Group 1 support 1 node, Group 2 - 4 support 5 nodes)
• Supports encryption mode: S0, S2
• Over The Air (OTA) firmware upgrades
• Explorer frame support
• Inputs: 6 x 1-pole potential free (5mm clearance), max 10V DC
• Input impedance: 10kΩ
• Outputs: 6 x 1-pole potential free (10mm clearance)
• Relay switches: AC1: 16A 250V AC, AC3: 750W (engine), AC15: 360VA
• Max. inrush current: 80A/20ms
• Contacts: Common and Normally Closed
• Rated voltage: 10 – 24V DC/8 – 24V AC
• Power consumption: 0,6W + 0,5W pr. active relay (max 4W)

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! This switch module have potential free relay output.

Click here to visit Heatit Support page for Z-DIN 616