Dimmer - ZW111

Z-Wave Plus flush-mounted Universal Dimmer from Aeotec - ZW111 with Power Metering feature.

Aeotec Nano Dimmer is a Z-Wave Smart Dimmer specifically used to enable Z-Wave command and control (on/off/dim) of any wall switches. It can report immediate wattage consumption or kWh energy usage over a period of time. In the event of power failure, non-volatile memory retains all programmed information relating to the unit’s operating status.
It can connect to 2 external manual switches to control the load ON/OFF independently. Its surface has a pin socket, which can be used for connecting to the touch panel, so you can also use the touch panel to control the Nano Dimmer. It can be used as "Electronic Switch" in 3-wire connection.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 150m free field, up to 30m in buildings
• Group for Association: 4 (Max 5 nodes per Group)
• Security: AES-128 encryption
• Support: Beaming and Z-Wave explorer frames
• Over The Air (OTA) firmware upgrades
• For resistive, inductive and capacitive loads (Do not connect any mixed loads)
• Supported Loads: (Look User/Installation manual for more information)
• Implemented algorithm for smart light source detection
• Auto-adjustment of the appropriate control mode (leading edge or trailing edge) to connected load
• Load for fan motor: Max 100W mono-phase asynchronous motor
• Soft start function
• With memory function of the last lighting level settings
• Works with various types of switches – momentary, toggle, three-way, etc.
• Dimmer type: Universal (bidirectional MOSFET switch)
• Rated Current Output: 1,2A maximum
• Supports both 2-wire and 3-wire connections
• Power measurement accuracy: ±3W
• Surge and Overload Protection
• Max standby power: < 1W

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! This dimmer module suitable also for dimming of halogen lighting and LED based lamps. The dimmer does not work for every installation, because not every transformer or LED can be dimmed. Dimmable electronic transformers and LEDs as standard is marked as "DIMMABLE". Note: 230V (HV) halogen lamps and some of the LED based light sources have very high starting current.
Non compatible light device may work but is likely can produce light flickering and (or) an audible humming or buzzing noise when dimmed. This noise and (or) flickering is usually a symptoms of internal stress, which in turn can cause failure of the connected device or dimmer. Always confer with professional installer.

Click here to visit Aeotec Support and Firmware Update page for Nano Dimmer

Click here to visit Aeotec Products Compatibility List