Dimmer - D080-ZV

Z-Wave Plus Plug-in Dimmer Module (EU-Schuko plug) - D080-ZV from HZC electric.

The D080-ZV is an innovative AC phase-cut dimmer with Z-Wave Plus control interface. The innovative minimum brightness setting function enables users to set a minimum brightness level.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 100m free field, up to 30m in buildings
• Group for Association: 1 (Max 5 nodes)
• Supports encryption mode: S0, S2
• Support: Beaming and Z-Wave explorer frames
• Over The Air (OTA) firmware upgrades
• Dimmer type: Trailing edge (bidirectional MOSFET switch)
• Supported Loads: 5 - 100VA LED, 5 - 100W Halogen/Incandescent lamps
• Innovative minimum brightness setting function
• With memory function of the last lighting level settings
• Max standby power: < 1W

Attention! This dimmer module suitable for dimming of low-voltage halogen lighting and LED based lamps. The dimmer does not work for every installation, because not every transformer or LED can be dimmed. Dimmable electronic transformers and LEDs as standard is marked as "DIMMABLE".
Non compatible light device may work but is likely can produce light flickering and (or) an audible humming or buzzing noise when dimmed. This noise and (or) flickering is usually a symptoms of internal stress, which in turn can cause failure of the connected device or dimmer. Always confer with professional installer.