Dimmer - D070K2-ZV

Z-Wave Plus flush-mounted Universal Dimmer - D070K2-ZV from HZC electric.

The D070K2-ZV is an innovative AC phase-cut dimmer with Z-Wave Plus control interface. The innovative minimum brightness setting function enables users to set a minimum and maximum level for brightness, also dimming speed level.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 100m free field, up to 30m in buildings
• Group for Association: 4 (Max 5 nodes per Group)
• Supports encryption mode: S0, S2
• Support: Beaming and Z-Wave explorer frames
• Over The Air (OTA) firmware upgrades
• Dimmer type: Trailing edge (bidirectional MOSFET switch)
• Supported Loads: 5 - 250VA LED, 5 - 250W Halogen/Incandescent lamps
• 1 inputs for existing wired wall switch
• Innovative minimum, maximum brightness and dimming speed setting functions
• Soft start function
• With memory function of the last lighting level settings
• Max standby power: < 1W
• Supports both 2-wire and 3-wire connections

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Attention! This dimmer module suitable for dimming of low-voltage halogen lighting and LED based lamps. The dimmer does not work for every installation, because not every transformer or LED can be dimmed. Dimmable electronic transformers and LEDs as standard is marked as "DIMMABLE".
Non compatible light device may work but is likely can produce light flickering and (or) an audible humming or buzzing noise when dimmed. This noise and (or) flickering is usually a symptoms of internal stress, which in turn can cause failure of the connected device or dimmer. Always confer with professional installer.