Dimmer - D684E2-ZV

Z-Wave Plus Wall Mounted Universal Dimmer - D684E2-ZV from HZC electric.

The D684E2-ZV is an innovative AC phase-cut dimmer with Z-Wave Plus control interface. The innovative minimum brightness setting function enables users to set a minimum brightness level.

• Communicates via Z-Wave Plus RF (868,42 MHz)
• Range: up to 100m free field, up to 30m in buildings
• Group for Association: 1 (Max 5 nodes)
• Supports encryption mode: S0, S2
• Support: Beaming and Z-Wave explorer frames
• Over The Air (OTA) firmware upgrades
• Dimmer type: MOSFET (Trailing edge dimmer)
• Supported Loads: 5 - 200VA LED, 5 - 300W Halogen/Incandescent lamps
• Input and Output with Screw Terminals, Safe and Reliable
• 1 inputs for one extra (wired) wall switch
• Innovative minimum brightness setting function
• With memory function of the last lighting level settings
• Max standby power: < 1W
• Installation: with 2-wires only (no neutral wire required)
• Suitable for surface-mounted boxes & flush-mounted boxes with or without screw holes

IMPORTANT! Must only be installed by an authorized electrical installer. Private individuals who want to carry out work on the electrical system themselves must first study information from dsb (Directorate for Civil Protection and Emergency Planning) - Electrical work: You can do this yourself

Note: The Dimmer Service Set: SDCP-01, SDCP-02 or SDCP-03 (that consists of frame, central plate and rotary knob) not included in this item delivery. Must be ordered separately. "Pine" diameter for the rotary knob: 4mm.

Attention! This dimmer module suitable for dimming of low-voltage halogen lighting and LED based lamps. The dimmer does not work for every installation, because not every transformer or LED can be dimmed. Dimmable electronic transformers and LEDs as standard is marked as "DIMMABLE".
Non compatible light device may work but is likely can produce light flickering and (or) an audible humming or buzzing noise when dimmed. This noise and (or) flickering is usually a symptoms of internal stress, which in turn can cause failure of the connected device or dimmer. Always confer with professional installer.